THOMSON SpeedTouch 510v5, Reference Manual

Page: 44 / 384

AutoPVC Commands
E-DOC-CTC-20040907-0010 v1.0
42
autopvc config
Configure autopvc.
SYNTAX:
where:
autopvc config [mode = <{pseudo | passive | active}>]
[type = <{bridge | pppoerelay}>]
[opmode = <{partial | full}>]
[overwrite = <{disabled | enabled}>]
[peakrate = <number{0-27786}>]
mode Select the autopvc mode:
pseudo :
enable only pseudo-ILMI (VP/VC 15/16). When connection parameters are
written to the MIB, display this information on CLI or web-interface but do not
use these parameters for configuration.
passive :
enable both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/VC 15/16). When connection
parameters are written to the MIB, display this information on CLI or web-
interface but do not use these parameters for configuration.
active :
enable both ILMI (VP/VC 0/16) and pseudo-ILMI (VP/VC 15/16). When connection
parameters are written to the MIB, use these parameters to configure
phonebook entries, qosbook profiles and bind bridge or PPPoE interfaces on
top.
The default is pseudo .
OPTIONAL
type Type of autopvc:
bridge
pppoerelay :
an ETHoA interface will be created, will be bound to the ILMI PVC and will be
added to the PPPoE relay as relay port.
The default is bridge .
OPTIONAL
opmode Operational autopvc mode:
partial : only read the ILMI VPC and VCC MIB tables
full : read all supported MIB tables.
The default is partial .
OPTIONAL
overwrite Enable/disable UBR peak rate overwrite.
The default is
enabled .
OPTIONAL
peakrate A number between 0 and 27786.
Represents the UBR peak rate (in kilobits per second).
Note
0 indicates the linerate.
OPTIONAL