THOMSON SpeedTouch 510v5, Reference Manual

Page: 145 / 384

Eth Commands
E-DOC-CTC-20040907-0010 v1.0
143
eth ifconfig
Configure the Ethernet port.
SYNTAX:
where:
RELATED COMMANDS:
eth ifconfig intf = <number>
type = <{auto | 10BaseTHD | 10BaseTFD | 100BaseTHD | 100BaseTFD}
or number>
intf The number of the Ethernet interface to be configured. REQUIRED
type The Ethernet type.
Select either:
auto : Auto negotiation of Ethernet communication speed (10Mb/s or 100Mb/s) and
Duplex mode (half duplex or full duplex).
10BaseTHD : 10Mb/s communication speed in half duplex mode.
10BaseTFD : 10Mb/s communication speed in full duplex mode.
100BaseTHD : 100Mb/s communication speed in half duplex mode.
100BaseTFD : 100Mb/s communication speed in full duplex mode.
or enter a number between 0 (auto) and 5 (100BaseTFD).
The default is
auto .
Note
This value should never be changed, except in case of communication
problems.
REQUIRED
eth iflist Show the Ethernet port configuration and current operating status.