Analyzer Operation
III-3
Thermo Scientific Orion 2120XP Calcium Hardness Analyzer User Guide
Before the first sample measurements can be taken, the setup mode should
be programmed and a successful calibration must be performed by the
operator and stored in the memory of the analyzer.
• Press
to enter the setup mode.
• SETUP appears in the mode indicator screen.
• HOLD is displayed while in the setup mode.
• The analyzer will enter the setup mode at the last menu that was used
by the operator.
• Press
and
to loop through the menu options.
• Press
to select the desired menu option and set the menu
option parameters.
• Press
and
to:
• Scroll between On and OFF for the selected menu option.
• Scroll and set the first digit value to 0 through 19.
• Scroll and set the remaining digit values to 0 through 9.
• Press
to move to the next digit (scroll right) to set each digit value
(4 digits maximum).
• Press
to save the entered parameter for the selected menu option.
• Press
to exit the current screen and return to the previous screen.
• Press
to exit the setup mode and return to the measure mode. If
is pressed,
will not return the operator to the setup mode.
The operator must reenter the setup mode by pressing
.
If a single channel analyzer is in use, all of the menu options are accessible
by pressing
/
in the setup mode. The system will loop through
the menu options and all of the menu options are in the same level of the
setup mode.
If a two channel analyzer is in use, only the general menu options are
accessible by pressing
/
in the setup mode. The channel 1 and
channel 2 specific menu options must be accessed by selecting the CH1 or
CH2 menu options in the setup mode. The channel specific menu options
are in the second level in setup mode. If a two channel analyzer is in use,
make sure to program both the channel 1 and channel 2 menu options in
the setup mode.
Use of the
Setup Mode
Navigating Tips for the
Setup Mode
Channel Specific Menu
Options in the Setup Mode
