Thermo Scientific dionex ic pure water, Operating Instructions Manual

Page: 53 / 128

Thermo Scientific Dionex IC Pure system |
43
Installation |
Chapter 7
3 Cut the 1/8“ feed tube from the IC system at the reducing adapter on the
Dionex IC Pure system and connect both ends of the 1/8“ tube as
described in “Connection of a Dionex Integrion and Dionex ICS-2100,
Dionex ICS-4000, Dionex ICS-5000
+
, Dionex ICS-5000 or Dionex
ICS-3000system on page 35, Step 4 and 5.
4 Take the 1/8“ feed tube for the second Dionex Integrion and Dionex
ICS-2100, Dionex ICS-4000, Dionex ICS-5000
+
, Dionex ICS-5000 or
Dionex ICS-3000 system and connect it to the top connection on the T
piece.
5 Switch the Dionex IC Pure system back on and activate pure water
pumping for both Dionex Integrion and Dionex ICS-2100, Dionex
ICS-4000, Dionex ICS-5000
+
, Dionex ICS-5000 or Dionex ICS-3000
system using the Chromeleon CDS software.
Step Action Figure
Note
Again, ensure that the cutting ring and the taper
coupling are installed correctly (see “Connecting the control
cable from the IC Pure system to a Dionex Integrion and Dionex
ICS-2100, Dionex ICS-4000, Dionex ICS- 5000+, Dionex
ICS-5000 or Dionex ICS-3000 system” , Step 4)
.
1/8“ tube
T piece
Note

The system must be switched off.

The feedwater supply must be closed.

Check that the IC System is not in operating mode.
Connecting the Suppressor to the Dionex IC Pure system
Step Action Figure
1 Switch off the Dionex IC Pure system and stop pumping of pure water
for the Dionex Integrion Dionex ICS-2100, Dionex ICS-4000, Dionex
ICS-5000
+
, Dionex ICS-5000 or Dionex ICS-3000 system using the
Chromeleon CDS software.
2 Take the reducing adapter supplied with the Dionex IC Pure system and
carefully unscrew the union nut from the fitting.
Note
Ensure that the cutting ring and taper coupling that fit
inside the union nut are not lost when you unscrew the union
nut.
Reducing adapter
Union nut