Thermo Scientific Accela UV/Vis Plus, Hardware Manual

Page: 47 / 86

2
Installation
Making the Back Panel Connections
Thermo Scientific Accela UV/Vis Detector Hardware Manual 31
Figure 38. Adapter cable for an Accela detector (P/N 60157-63026)
 To make the connect closure connections for a stand-alone LC system with an
Accela Open Autosampler, Accela pump (all models), and an Accela UV/Vis Detector
1. Connect the Accela Open Autosampler system interconnect cable as follows:
a. Plug the DB15 connector into the Interface 1 receptacle on the back panel of the
Accela Open Autosampler.
b. To connect the Accela pump (all models), do one of the following:
i. For an Accela 600 Pump or Accela 1250 Pump, plug the 25-pin connector into
the D-Sub25 receptacle on the pump’s back panel (see
Figure 39 ).
ii. For an Accela Pump, plug the 25-pin connector into 25-socket connector of the
Accela Pump adapter cable (see Figure 40 ) and plug the other end of the adapter
cable into the D-Sub25 receptacle on the pump’s back panel.
2. To connect the adapter cable to the interconnect cable, plug the 2-pin male connector
labeled TO 60157-63024 on the adapter cable into the 2-pin female connector on the
interconnect cable.
3. Connect the adapter cable connector labeled TO PDA to pins 1 through 8 on the
UV/Vis detector’s back panel.
Figure 39 shows the contact closure connections for a stand-alone Accela LC system with an
Accela Open Autosampler, Accela 600 or 1250 Pump, and Accela UV/Vis Detector.
Figure 40 shows the contact closure connections for a stand-alone Accela LC system with an
Accela Open Autosampler, Accela Pump, and Accela UV/Vis Detector.
TO 60157-63024 60157-63026 TO LC Q FLEET
TO LT Q /LX Q /M SQ
TO T SQ /EXACTI V E
TO PDA
2-pin male
connector
2-pin female
connectors
8-pin female
connector
23 cm (9 in.)
200 cm (79 in.)