Thermo Scientific Accela UV/Vis Plus, Hardware Manual

Page: 41 / 86

2
Installation
Making the Back Panel Connections
Thermo Scientific Accela UV/Vis Detector Hardware Manual 25
Figure 32. Standard analytical flow cell cover installed
Making the Back Panel Connections
Use the cables provided in the UV/Vis detector accessory kit to make the back panel
connections.
For a stand-alone Accela LC system, you must connect the UV/Vis detector to the data system
computer as described in
“Connecting to the Data System Computer.” You must also
connect the system interconnect cable that transmits the start signal from the autosampler to
the detector during an injection cycle as described in
“Connecting the System Interconnect
Cable or Cables.”
If you are using an autosampler that is not controlled from your Thermo Scientific data
system, use the remote communications pins on the detector’s back panel to trigger the
detector as described in
“Making Remote Communications Connections.”
To make the back panel connections, follow these procedures:
• Connecting to the Data System Computer
• Setting the Unit ID
• Connecting the System Interconnect Cable or Cables
• Connecting the Analog Outputs
• Setting the Analog Output Voltage
• Making Remote Communications Connections
Thumbscrew