Thermo Scientific 3600 PDM, Manual

Page: 33 / 132

Basic Operation
PDM Display
Thermo Fisher Scientific PDM 3600 Instruction Manual 2-9
3. Turn the tool upside down, place the bottom of the spring loaded filter
exchange tool on top of the filter and apply downward pressure until
the filter tool stops (
Figure 2–15 and Figure 2–16 ).
Figure 2–15. Back of filter exchange tool
Figure 2–16. Setting the filter
4. Install the mass transducer back into the PDM unit.
When not running a sample, the PDM will automatically turn off its LED
display after 30 seconds of inactivity (power-save function). However,
during the warmup time and sampling cycle, the PDM will continue to
activate its LED display until the sample run ends. At the end of the sample
run, after 30 seconds of inactivity, the PDM will then automatically turn
off its LED display. If the PDM is connected to the WinPDM software,
the PDM display will stay on continuously.
The display on the top panel ( Figure 2–17 ) of the TEOM 3600 PDM
allows for easy navigation through the instrument’s firmware screens by
pressing the “A” or “WAKE UP” button and the “B” or “SCROLL”
button.
Figure 2–18 provides a hierarchy of all the firmware screens that
can be accessed by pressing the “A” and “B” buttons when the unit has
been set up to run a manual sample run.
PDM Display