Thermo Pride OD6FA072D48, Installation, Operation And Service Manual

Page: 12 / 43

11
Direct Venting
The OD6 may also be horizontally vented through a side wall. Direct venting is
only allowed when using the approved Direct Vent Termination kit and Direct
Vent Accessory kit listed in the table below, and is limited to a maximum length
of 15’.
Table 2: Side wall vent kits
The Direct Vent Termination kit consists of a concentric through-the-wall vent
termination/inlet air vent hood and 15’ of Stainless Steel Insulated Flexible Pipe
that requires 2” clearance to combustibles.
A field supplied smooth wall 4” combustion air pipe will need to be provide to
connect the combustion air from the termination hood to the burner. The direct
vent accessory kit will provide the fittings needed to connect the 4” pipe to the
burner. The combustion air inlet can be installed through the either the lower left
or right side casing knock-out.
For proper installation follow the Instruction provide with the Direct Vent
Termination Kit.
Power (Side-Wall) Venting – Important Note Regarding
c
CAUTION: Thermo Products, LLC will NOT assume responsibility for
damage to, and deterioration of, exterior building materials, e.g. brick,
siding, clapboards, and etc., in close proximity to the vent terminal due to
operation of a power vented, oil furnace. This policy is applicable
regardless of the cause of sooting.
NOTICE: Thermo Products recommends the use of a chimney to vent
residential oil furnaces. If a power venter must be used, it is the
responsibility of the installer and power venter manufacturer to design,
assemble, and demonstrate proper operation of the power venting system
with the furnace.
SIDE WALL VENTING APPLICATION ORDER INFORMATION
BURNER
VENT TERMINATION KIT
(15’ application MAX)
PART NUMBER
SIDE WALL VENT
ACCESSORIES KIT
PART NUMBER
Beckett AFG AOPS8393 AOPS8394
Riello BF3 AOPS8393 AOPS8395
Carlin EZ-1HP AOPS8393 AOPS8432