Thermo King KD-II SR, Manual

Page: 55 / 182

Remote Control Panel Features (Rev. 04/03)
41
ALARM CODE DEFINITIONS
Always record any alarm codes shown.
Alarm codes preceded by a dash (-) were detected during a Unit Self Check
Stored Check Shutdown Code Description
00 No Fault
X 01 Microprocessor Power Up Reset
X 02 Evaporator Coil Sensor
X 03 Return Air Sensor
X 04 Discharge Air Sensor
X 05 Ambient Air Sensor
X 06 Engine Water Temperature Sensor
X X 07 Engine RPM Sensor
X X 09 High Evaporator Temperature
X 10 High Discharge Pressure or Compressor Temperature
X 11 Unit Controlling on Discharge Air Sensor
X 12 Sensor Shut Down
X 17 Engine Failed to Crank (CYCLE SENTRY)
X 18 High Engine Water Temperature
X 19 Low Engine Oil Pressure
X 20 Engine Failed to Start (CYCLE SENTRY)
X 21 Cooling Cycle Check
X 22 Heating Cycle Check
X 23 Cooling Cycle Fault
X 24 Heating Cycle Fault
X 25 Alternator Check
X 28 Unit Self Check Abort
X 31 Oil Pressure Sensor
X X 32 Refrigeration Capacity Low
X 33 Check Engine RPM
X 35 Run Relay Circuit; High Compressor Temperature Still Open
X 36 Electric Motor Failed to Run
X 37 Check Engine Water Level
X 38 Electric Phase Reversed or Motor Overload Tripped
X 40 High Speed Circuit
X 52 Heat Circuit
X 54 Test Mode Timeout
X 61 Battery Check
X 63 Engine Stopped—Reason Unknown
X 66 Low Engine Oil Level
X 70 Hourmeters Exceed 99999 Hours
X 71 Hourmeter 4 Exceeds Set Limit
X 72 Hourmeter 5 Exceeds Set Limit
X 73 Hourmeter 6 Exceeds Set Limit