Thermo King KD-II SR, Manual

Page: 139 / 182

Hilliard Clutch Maintenance (Prior 4-97) (Rev. 04/03)
125
3. Install spacers and fill cavity with Mobil 28 grease
(TK No. 203-394).
4. Press second bearing in—seal side up.
5. Place Elatomer bushing and metal bushings in shoes
and hub.
6. Position shoes in a circle on a flat surface and install
springs on shoes.
7. Position shoes on hub.
8. Install 1/4 x 1-3/4 in. screws through links, then slide
through bushings in shoes and hub.
NOTE: Threaded end of screws should be on flange
side of hub. See drawing for correct position.
9. Install remaining links and 1/4-28 locknuts, torquing
them to 85 to 90 in-lb (9.9 to 10.5 N•m).
NOTE: Shoes must be held tightly against hub while
nuts are tightened.
10. Place hub into housing.
NOTE: If bearings do not slide easily onto the hous-
ing shaft, use an arbor against the inner bearing race
and press unit together.
Bearing Race Insertion
11. Apply Loctite #680 to 3/8-16x1 screw and install
through washer into housing shaft. The housing and
hub will be drawn together to the proper relative posi-
tion as the screw is tightened. Tighten the screw to 215
to 220 in-lb (24 to 25 N•m).