Thermo King KD-II SR, Manual

Page: 130 / 182

Refrigeration Service Operations (Rev. 04/03)
116
KD-II SR Compressor Pulley Removal and
Installation
KD-II SR units will have an anti-seize lubricant on the
tapered surfaces of the two-piece compressor pulley. The
anti-seize lubricant facilitates the installation and removal
of the two-piece pulley. To ensure correct pulley alignment,
all rust and/or paint should be removed from the tapered
portion of both the pulley and hub, and the mounting screws
Anti-Seize Lubricant Application
1. Apply Anti-Seize Lubricant to the Tapered Surface of the Bushing Only.
2. Bushing
3. Torque Evenly to 7 to 10 ft-lb (23 to 14 N•m)
4. Clean All Rust and Paint Off These Tapered Surfaces Before Installing.
5. Pulley
should be torqued to 7 to 10 ft-lb (23 to 14 N•m). Whenever
the two-piece pulley is removed from any type of unit ser-
vice, anti-seize lubricant should be applied to the outside of
the tapered surface on the pulley bushing. Use one of the
following recommended anti-seize lubricants: Fel-Pro C5-
A, Loctite 767, Never-Seez NS-12, or Never-Seez NS-160.