Thermal Arc POWERMASTER 400SP, Service Manual

Page: 41 / 110

Octobe r 30, 2008 4-7
POWERMASTER 400SP, 500SP AUTOMATION
c. Hold the “TT Ente r ” push-button (47)
p r essed fo r two seconds (the decimal point
between the job set and the job numbe r lights
up).
5. Re-saving/Re-p r og r amming jobs:
a. Switch the Tipt r onic function on by p r essing
“Tipt r onic” (49) and select a job (see Selecting
Jobs).
b. Change the settings as r equi r ed.
c. P r ess the “TT Save” button (45) (Save LED
flashes).
d. P r ess “TT Ente r ” button (47) to confi r m.
e. The Save and Ente r LEDs flash b r iefly to
confi r m that p r og r amming is te r minated.
6. Copying jobs:
a. Switch the Tipt r onic function on by p r essing
“Tipt r onic” (49) and select a job fo r copying
(see Selecting Jobs).
b. P r ess the “TT Save” button (45) (Save LED
flashes).
c. Select the ta r get job numbe r with the push-
buttons (44) (-) and (48) (+) and confi r m with
the “TT Ente r ” pushbutton (47) (if the Ente r
pushbutton is not actuated, the Save LED goes
out 10 seconds afte
r the last pushbutton
actuation and the saving p r ocedu r e is
cancelled). If the ta r get job numbe r has not
been occupied with a job yet, it is indicated by
the display flashing.
d. The Save and Ente r LEDs flash b r iefly to
confi r m that p r og r amming is te r minated.
The use r -defined job texts a r e also copied
onto the new ta r get job numbe r .
7. Assigning desc r iptive text to a job:
Text can be assigned to each job in o r de r to
identify it mo r e clea r ly.
a. Switch on the Tipt r onic function with the
“Tipt r onic” pushbutton (49) .
b. Select the job numbe r with the push-buttons
(44) (-) and (48) (+).
c. P r ess the and push-buttons (51) at
the same time (a flashing cu r so r appea r s in
the display (50) ) in o r de r to get into the edit
mode.
d. The cu r so r is moved with the and
push-buttons (51) . At the end of the line, the
cu r so r jumps to the r espective next line.
e. Select a cha r acte r (numbe r , lette r o r special
cha r acte r ) with push-buttons (44) (-) and (48)
(+).
f. The edit mode is ended by p r essing
pushbutton (46) (END) o r by p r essing the
and push-buttons (51) at the same time.
If you p r ess the “Tipt r onic” pushbutton (49)
in edit mode (Tipt r onic is switched off), then
the text ent r ies will not be saved.
Texts can be p r og r ammed both fo r the job set
(uppe r line in display (50) ) as well as fo r the job
(bottom line in display (50) ).