Themis NanoPAK, User Manual

Page: 51 / 156

2-19
Themis Computer
2—Installation and Operation
Power Consumption
1. If the I/O cable is connected, remove it using the .050in, (H1.3 European), hex
wrench.
2. Remove two Phillips head screws on each side of the front of the module.
3. Remove the two jack screws at the connector with the 3.5mm socket driver.
4. Remove the front panel.
5. Remove the old battery from the battery holder. It may be necessary to use
tweezers or a needle nose pliers in order to grip the old battery. Note that if the
tool does not have insulated surfaces, you will short the battery unless you
grip only the rim of the battery.
6. Install the replacement battery, plus side down, by sliding it into the battery
holder.
7. Replace the front panel. Insert and tighten the two jack screws into the con-
nector holes.
8. Replace and tighten the two Phillips head screws in the sides.
9. Reinstall the I/O cable if desired, using the .050in, (H1.3 European), hex
wrench. Caution! Insure that power is removed from the power contacts to
avoid possible damage to the system. Apply power only after the connector is
secured in place.