The Wine Square CUBE LT, User Manual

Page: 19 / 60

17
5
Connect the tubes previously installed in the walls with the radiator module. The
tubes preinstalled on the radiator are connected directly to the PEX fittings without
a crimp ring. The tube is therefore installed on the PEX tip as it will be on a barb
fitting.
Insulated Tube Non-insulated Tube
Make sure that the connection with the tubes is above the condensation
pan. Otherwise, take care to insulate the PEX and fitting to avoid condensa-
tion.
6
Install a connector at the end of the RJ45 wire and connect the wire to the
RC4LT
electronic board. The wire can be plugged into any of the two connectors on the
board.
CAUTION Be sure to always test your cable with an RJ45 cable tester be-
fore plugging the wire into the device. Reversing two wires when installing
the connector could damage the product electronics.