The Wine Square CUBE LT, User Manual

Page: 17 / 60

15
2
Check that the backing plate is level in
both axes. If necessary, use shims be-
tween the ceiling and the plate to level
everything. If the support is not level, the
condensation generated by the system
may drip to the floor rather than being
picked up by the condensation pump.
FINAL INSTALLATION
This installation step must be carried out at the very end of the work when there is no lon-
ger any dust production. Otherwise, dust could damage the device and reduce the cool-
ing capacity of the system. In the event that construction steps are required following the
installation of the system, please unplug the device before starting work.
FINAL INSTALLATION RC4LT
1
Locate the
RC4LT
in the wine cellar. Using
# 8 flat-head wood screws, long enough to an-
chor into the nailing base without risking drilling
the PEX tubes installed in the ceiling, secure the
RC4LT backing plate. Take the time to make sure
the plate is parallel with the walls.
The bended edge of the mounting
plate should be the side of the plate
closest to the back wall of the wine
cellar.