Thales Cinterion MV31-W, Hardware Interface Description

Page: 21 / 76

Cinterion ® MV31-W Hardware Interface Description
3.1 Pin Assignments and Electrical Description
75
t
MV31-W_HID_v01.009a 2022-04-27
Public / Preliminary
Page 21 of 76
47 PERn0 1st PCIe
®
lane Rx+/-, Section 3.2.7 Input
49 PERp0
51 GND
53 REFCLKn PCIe
®
Reference Clock, Section 3.2.7 Input
55 REFCLKp
57 GND
59 mmWave_Enable_1 Reserved for mmWave product variant Output 1.8V
61 mmWave_Enable_2 Reserved for mmWave product variant Output 1.8V
63 mmWave_Enable_3 Reserved for mmWave product variant Output 1.8V
65 mmWave_1P85 Reserved for mmWave product variant Output 1.9V
67 RESET# Asynchronous RESET, Section 3.2.2.2
(not supported by MV31-W)
Input 1.8V
69 CONFIG_1 Add-in Card Configuration 1, Section 3.2.12 Output
71 GND
73 GND
75 CONFIG_2 Add-in Card Configuration 2, Section 3.2.12 Output
2 3V3 Power supply 3.3V, Section 3.2.1
4 3V3
6 FULL_CARD_POWER_OFF# Section 3.2.2.3 Input 3.3V
8 W_DISABLE1# Disable WWAN on the Data Card, Section 3.2.2.1 Input 3.3V
10 LED_1# Active low signal, Section 3.2.11 Output Open
drain
Key ID B
20 internal not
connected
22 ANT_TUNER_CONFIG Antenna tuner mode control, Section 3.2.3.2 Input 1.8V
24 ANT_TUNER_POWER Antenna tuner power Output 1.8V
26 W_DISABLE2# disable GNSS on Data Card, Section 3.2.2.1 Input 3.3.V
28 DPR_2 Dynamic Power Reduction (SAR), Section 3.2.5 Input 1.8V
Table 2: Pin assignments
Pin
No.
5G M.2 Data Card
MV31-W
pin name
1
Comments PIN Type