71
9-7-25. Sending ID data (Response to the ST3 command)
MS3
，＊＊，＊＊
・
The system address and equipment ID are sent in response to the ST3 command.
9-7-26. Sending output voltage, output current or operation mode (Response to the ST4 command)
・
The output voltage, output current, and operation status requested by the ST4 command are sent
in real numbers. The message format is the same as MS0 shown in “9-7-22.”.
9-7-27. Sending all preset values (Response to the ST5 command)
・
Data in all preset memories requested by the ST5 command are sent in real numbers.
The message format is the same as MS1 shown in “9-7-23.”.
9-7-28. Sending power supply data (Response to the PWID command)
・
Response to the PWID command
NOTE: When the IF-40 series of the following model is used, “XXX” is returned as the model name.
PW8-3AQP
、
PW16-2ATP
、
PW8-5ADPS
、
PW24-1.5AQ
The model names of the PW18-1.3ATS and PW26-1ATS are PW18-1.3AT and PW26-1AT.
9-7-29. Sending address of controlled unit (IF-41GU/IF-41USB only)
・
Response to the PW? command
