Tescom TC-3000C, User Manual

Page: 93 / 128

Low Energy Command List
85
10. READ:SYS:DUT:PATH_LOSS?
○
Definition : Read the path loss
○
Response : 0 ~ 80, 0(defalult)
11. CONF:SYS:DUT:PATH_LOSS
○
Definition : Setup the path loss
○
Value : 0 ~ 80, 0(default)
12. READ:SYS:DUT:BAUDRATE?
○
Definition: Read the transfer rate according to DUT’s HCI transport layer type.
○
Response : 2400 ~ 115200
13. CONF:SYS:DUT:BAUDRATE
○
Definition: Set up the transfer rate according to DUT’s HCI transport layer type; may be set only in
case of UART or BCSP, 2WIRE
○
Value : 2400 ~ 115200
14. READ:SYS:DUT:IGNORE_FLOWCTRL?
○
Definition: Read the ‘Ignore_flowctrl’ parameter
○
Response : ON, OFF
15. CONF:SYS:DUT:IGNORE_FLOWCTRL
○
Definition: When the tester send ‘le_transmitter_test’ or ‘le_receive_test’ command,
‘Num_HCI_Command_Packet(zero)’ parameters corresponding value to ‘command Complete
Event’ is set to be effective or disregarded. (TC-3000C firmware version 3.50 or later and TI
CC254X BLE Software Stack users should set this parameter “ON”) Value : ON, OFF
○
ON: Operates via parameter
○
OFF: disregards the parameter
The commands that contain "LE" is exclusive commands for BT_LE. If DUT_TYPE value is BT or
GENERAL, "unknown command error" message will be returned. DUT_TYPE has to be
changed to BT_LE before using commands that contains "LE".
(CONF:SYS:DUT:DUT_TYPE BT_LE )
5.2.2 Output Power(OP) Command
1. EXEC:LE_RFTC:OP:RUN
○
Definition: Start the test. Measure the maximum and average output power.
2. EXEC:LE_RFTC:OP:STOP