Tescom TC-3000C, User Manual

Page: 21 / 128

Setup
13
●
DUT Preparation : Connect HCI (UART or USB) and 2-wire UART Interface to TC-3000C.
●
Shield Box : For reliable measurement report, use a shield box to prevent electromagnetic
interferences. Depending on the DUT type, directly connect to the RF cable or create a radiation
environment using the antenna coupler.
●
TC-3000C : Select the BT LE Mode. (See 2.1.2 TC-3000C Setup )
2.1.2 TC-3000C Setup
1. BT LE Mode Setup
○
Select MENU -> Configuration -> DUT(M2) -> DUT Type(F2) -> BT LE
After TC-3000C Firmware Version 4.00, it will take less than 10 seconds to switch from BT to
BT LE mode.
2. HCI Port Setup: Set up the HCI port for DUT.
○
Select MENU -> Configuration -> DUT(M2) -> (F3) -> USB2 or UART2 or 2WIRE2
When setting up the HCI port, use UART2 or 2WIRE2 because the UART1 or 2WIRE1 port is
used for PC remote programs.
3. Baud Rate Setup: Set up the Baud rate for DUT.
○
Select Menu -> Configuration -> DUT (M2) -> Baud Rate (F4) and choose between 2400 and
115200.
When USB connection is used, Baud Rate does not need to be selected.
4. Path Loss Setup
○
Menu -> Configuration -> DUT (M2) -> Path Loss (F7)
○
Measure path loss from TC-3000C to DUT.