Terumo BCT Trima Accel, Service Manual

Page: 291 / 340

Table 5-2: Latch plate adjustment (continued)
Left Side Gap Right Side Gap Adjustment
Greater than 3/16 in Less than 3/32 in Leave the left screw closest to the door edge tight, and slightly (¼
turn) loosen the other three screws that secure the latch plate.
Slowly rotate the latch plate around the tighter screw so that the
right side is sticking farther out of the door.
Greater than 3/16 in Greater than 3/16 in Loosen all 4 screws (¼ turn) and move the entire latch plate so that
less of the plate is sticking out of the door.
5. Remove the screws holding the side of the door link arms. Support the door; it will fall to the floor
when these two screws are released.
6. Using a pencil, mark the corners of the latch plate. This will help you return to the starting point if
you over-adjust.
7. Perform the adjustment determined in step 4.
8. Open and close the door. Verify that the door does not contact the pump panel when closing.
9. Open the door slightly and release it; verify that the door does not hit the rubber stops. If it does, the
springs or air shocks need to be replaced.
Maintenance and Calibration
5-4 Trima Accel
®
Automated Blood Collection System • Service Manual