Terex Genie S-60 HF, Service And Repair Manual

Page: 52 / 217

Service and Repair Manual April 2021
Platform Components
40 S ® -60/65 XC ™ • S ® -60/65 HF • S ® -60/65 TraX ™ Part No. 1288652GT
How to Perform a Full Load Platform Calibration How to Perform a Full Load
Platform Calibration
Perform this procedure if the platform support or
load cell sensor has been replaced, or if a zero
load platform calibration does not return the
machine to full load capacity.
Note: Perform this procedure with the machine on
a firm, level surface.
1 Fully retract and lower the boom. Level the
platform.
2 Remove all weight, tools, accessories and
equipment from the platform.
Note: Remove the welder (if equipped).
Tip-over hazard. Failure to
remove all non-integrated
factory and non-factory options
and accessories could result in
the machine tipping over,
causing death or serious injury.
3 Enter Service Mode. Refer to Repair
Procedure,
How to Enter the Service Mode
.
4 Press the settings button above the display
and select the Calibrations menu.
5 Navigate to the Sensor calibration screen.
6 Navigate to the Load Sense calibration
screen.
7 Select and start the calibration procedure.
8 Follow the on-screen prompts to set the zero
load.
9 Continue with the on screen prompts to set
the maximum load.
10 Place a test weight on the platform floor using
a suitable lifting device. Place the weight near
the center entry point of the platform, as far
away from the operator controls as possible.
Weight = 1,000 lbs / 454 kg
Note: If test weights are not available, you may
use an industrial scale to weigh available objects
until it equals the platform’s maximum capacity.
Note: Alternate method for achieving rated load in
the platform is to attach a hanging scale to the
bottom of the platform and apply load using a
winch or chain hoist until the readout displays the
appropriate weight.
Platform hidden from illustration for clarity
1 platform support
2 hanging scale
3 winch or chain hoist
4 anchoring device