Terex Genie S-60 HF, Service And Repair Manual

Page: 44 / 217

Service and Repair Manual April 2021
Control System
32 S ® -60/65 XC ™ • S ® -60/65 HF • S ® -60/65 TraX ™ Part No. 1288652GT
8 Install the new DISCON onto the ground box
lid and fasten it using the new hex nuts and
washers. All five fastening points must be
used. Attach the DISCON door's lanyard to
the DISCON's mounting stud.
9 Evenly tighten the nuts, beginning with the
lower center nut, working out and then up.
10 Install the new ribbon cables, connecting the
ground box overlay to the DISCON and
reinstall the DISCON door, using the Torx
head screws removed in step 4. Be sure to
fully lock the tabs after the ribbon cables have
been fully inserted.
11 Reconnect the wire harness going to the
DISCON, then close and fasten the ground
box lid.
12 Reconnect the negative terminal to the start
battery and auxiliary batteries, if equipped.
1-8 How to Replace the Ground Control Overlay 1-8
How to Replace the Ground Box
Control Overlay
1 Push in the red Emergency Stop button to the
off position at both the ground and platform
controls.
2 Disconnect the negative terminal from the
start battery and auxiliary battery, if equipped.
3 Open the ground control box and remove the
switch contacts from the function enable
switch, key switch and the red emergency
stop button. Do not disconnect the wires.
Insert a small screwdriver into the loop at the
base of the contacts and engage the release
mechanism.