4
4
2.
SAFETY MEASURES
This section will provide guidelines on how to use WirelessCOM/G10 device safely. We
suggest you to adhere to following recommendations so as to avoid any damage to person or property.
You have to be familiar with the safety requirements before you start using the device!
Installation and technical support of the device can be performed
only by a qualified personnel or a person who has enough
knowledge about this device and safety requirements.
The device requires 9 V power supply. Available power supply source range is 6 V up to
15 V, power up to 3500mW.
The PC and power supply source to which the device is
connected should satisfy LST EN 60950-1 standard.
WirelessCOM/G10 modem can be used on first (Personal
Computer) or second (Notebook) computer safety class.
To avoid mechanical damage of the device, it is recommended to transport the device
packed in damage-proof pack.
While using the device, place it such that the LEDs are visible to the user. It’s because
these LEDs provide information about the working modes and conditions of the device.
Signal level of the WirelessCOM/G10 depends on the environment in which it is
working.
If the device fails to work properly only qualified personnel may repair this product. We
recommend to disconnect the device and forward it to repair centre or to the manufacturer. The
modem does not contain any parts which can be replaced.
At the installation site, supply circuits must have protective devices (bipolar release
device) which provide protection from short-circuit and wrong ground installation. The power of
connected device should satisfy power of release device. The interstice between contacts should be no
less than 3mm. Power supply network should be installed near the device on an easily accessible place
