19
19
23. PASSWORD
*set password xxx#
*get password#
24. BEARER FAIL REPORT
*set bearer_fail_report xxx#
*get bearer_fail_report#
25. CLOCK
*set clock xx:xx#
*get clock#
26. AUTOCONNECT
*set autoconnect xx:xx#
*set autoconnect xxxx#
*get autoconnect#
Table 7.2 WirelessCOM/G10 configuration through CSD and GPRS
* Changes in mode, bearer will take place only after you will restart the WirelessCom/G10. It is
possible to restart WirelessCom/G10 remotely by using the command *restart#. We recommend you
to check all the settings and restart WirelessCom/G10 after you are done with remote
configuration.
7.7 Configuration through SMS
After WirelessCom/G10 registers to the network, it scans for SMS every 5 seconds. SMS can
be used to configure/get parameters of WirelessCom/G10. Access through SMS is allowed only to an
authorized phone number. Currently five authorized numbers are allowed.
Nr.
Parameter
Syntax
Description
1. GET1
get1
Gets the information about the
essential GPRS configuration
parameters of WirelessCOM/G10.
(Format of received SMS is
explained in later section)
2. GET2
get2
Gets the information about the
essential CSD configuration
parameters of WirelessCOM/G10.
(Format of received SMS is
explained in later section)
3.
RESTART
restart Restarts
WirelessCOM/G10
4.
SERVER IP
ADDRESS
ip xxx.xxx.xxx.xxx set
e.g: ip 192.168.2.1 set
Sets the IP address of server
5. SERVER
PORT port xxxx set
e.g: port 1234 set
Sets the server port
6. APN
apn xxxxxxxxxx set
e.g: apn web.gsm set
Sets APN
7. MODE
mode xxxxx set
mode slave set
Sets the mode of device. Master,
slave or master_ar
8. AUTH
PHONE
auth_********** set
e.g: auth_1234567890 set
(Similarly you can set auth_phone2,
auth_phone3, auth_phone4)
Sets the authorized SMS phone
number.
Table 7.3: WirelessCOM/G10 configuration through SMS
