22
22
If bearer_fail_report is turned on, WirelessCom/G10 is programmed to send SMS for
conditions which would result in no connection (GPRS/CSD). The conditions and the format of
received SMS are as explained below,
1) Initialization of GPRS was not successful. This condition may occur if either of
apn, username or userpassword is not configured properly.
GPRS initialization failed MODE[ ]IP[ ]SER_PRT[ ]LOCALPRT[ ]APN[
][USR: ,PSWD: ]
2) WirelessCom/G10 was not able to connect to server (GPRS). This condition will
arise in master mode if server_ip or server_port parameters are not configured
properly.
Connection to server failed DEV_ID[ ]IP[ ]SER_PRT[ ]APN[ ][USR:
,PSWD: ]RETRY_TO[ ]CONN_TO[ ]
3) WirelessCom was not able to create a server (GPRS). This condition will arise in
slave mode if local_port was not configured properly.
Server creation failed DEV_ID[ ] GPRS[ ] LOCALPORT[ ] APN[ ] [USR:
,PSWD: ]
4) WirelessCom could not activate GPRS. This condition may occur if any of the
following configuration parameters were not configured properly, apn, username,
userpassword, It may also happen if GPRS service is not activated on the SIM card.
GPRS activation failed DEV_ID[ ]MODE[ ]IP[ ]SER_PRT[ ]RETRY_TO[
]APN[ ][USR: ,PSWD: ]
5) CSD connection could not be established. This may happen if authorized phone
numbers were not properly configured.
CSD call failed DEV_ID[ ]MODE[ ]AUTH_PH[ , , , ]CSD_PH[
]RETRY_TO[ ]CONN_TO[ ]
6) CSD call generated from WirelessCom/G10 was not answered.
CSD call not answered DEV_ID[ ]MODE[ ]AUTH_PH[ , , , ]CSD_PH[
]RETRY_TO[ ]CONN_TO[ ]
