14
14
Using this command, WirelessCOM/G10 will store the pin in its memory and
whenever the device restarts WirelessCOM/G10 will enter the pin automatically. To
save a pin type
pin xxxx
where xxxx is the pin of your sim card, and press
enter/return key.
7) puk:
If you have a sim card with enabled puk, WirelessCOM/G10 gives you the
possibility to enter the puk (of sim card) automatically each time the device restarts.
Using this command, WirelessCOM/G10 will store the puk in its memory and
whenever the device restarts WirelessCOM/G10 will enter the puk automatically. To
save a puk type
puk xxxx
where xxxx is the puk of your sim card, and press
enter/return key.
In addition to the above commands, there are commands for preset connection
profiles of GPRS and CSD connections. Using these commands you can set the
configuration settings for a particular bearer and mode to typical values. They are as
explained below,
8) gprs_master:
This command will set WirelessCOM/G10 to gprs master mode
configuration with typical values (factory configured). Just type
gprs_master
and press
enter/return key.
9) gprs_slave:
This command will set WirelessCOM/G10 to gprs slave mode
configuration with typical values (factory configured). Just type
gprs_slave
and press
enter/return key.
10) csd_master:
This command will set WirelessCOM/G10 to csd master mode
configuration with typical values (factory configured). Just type
csd_master
and press
enter/return key.
11) csd_slave:
This command will set WirelessCOM/G10 to csd slave mode
configuration with typical values (factory configured). Just type
csd_slave
and press
enter/return key.
* Whenever you have configured WirelessCom/G10, before restarting the device use the test
command. The command will test WirelessCom/G10 with your current configuration settings and
check if connection is possible or not. However if you had made changes to mode, bearer or
bearer_retry_timeout, you would need to restart the modem and then use the test command
