16
16
86400. Typical value is 200
10. CALL
TYPE
set call_type xxx
get call_type
Call type can be analog or isdn. Typical
value is isdn.
11. USER
NAME
set username xxx
get username
user name for gprs connections which
require CHAP/PAP authentication
12. USER
PASSWORD set userpassword xxx
get userpassword
Password for gprs connections which
require CHAP/PAP authentication.
13. AUTHENTICATION
PROTOCOL
set auth_protocol xxxx
get auth_protocol
Sets the authentication protocol. Value
can be none, chap, pap.
14. LOCAL
PORT
set local_port xxx
get local_port
Sets local port to listen for incoming
connections. Value should be from 0 to
65535.
15. SERVER
IP
set server_ip xxx
get server_ip
Remote server IP. Valid IP format is:
xxx.xxx.xxx.xxx
16. SERVER PORT
set server_port xxx
Remote server port. Value should be from
0 to 65535.
17. BEARER RETRY
TIMEOUT
set bearer_retry_timeout
xxx
get bearer_retry_timeout
It decides the time for which
WirelessCOM/G10 should try to connect
to a server (GPRS) or make a call (CSD).
Value (in seconds) should be from 0 to
300. If the value is “0”, then the device
keeps trying infinitely.
*Restart is required after you set this parameter
(in order for the change to take effect)
18. PING
set ping xxxx
get ping
This is a timeout which would send an
empty packet to the server (if connection
is established) after the timeout occurs.
This timeout can also be called as
keep
connection alive
timeout. Many times
operators drop GPRS connections if a
traffic is not detected on a particular
connection, this timeout can help to
prevent such situation.
19. APN
set apn xxx
get apn
Access Point Name
20. CSD
PHONE
set csd_phone xxx
get csd_phone
CSD connection phone number.
21. AUTHORIZED
PHONE NUMBER
set auth_phone1 xxx
get auth_phone1
(similarly auth_phone2,
auth_phone3,
auth_phone4)
Sets authorized phone number for
accepting, sending SMS. Authorized
numbers for accepting CSD calls in slave
mode. Calls and SMS coming from other
phone numbers would be rejected. Valid
phone format is: +xxxxxxxxxxx
22. DEVICE
ID
set device_id xxx
get device id
Gives an ID for the device. If configured
this ID will be transmitted along with data
transferred over GPRS/CSD. The ID will
be included only in the first packet. Any
character/string with numeric or
alphanumeric values.
This parameter is helpful if you have more
than one WirelessCom in the field. You
can enter name of city/address and it will
be easier for you to recognize from which
