17
17
device the data came.
23. *PASSWORD
set password xxx
get password
Password protection for configuration of
WirelessCOM/G10. If configured, after
restart, entry to configuration console
would be possible only after correct
password.
Any character/string with numeric or
alphanumeric values. No spaces allowed.
Maximum characters 10.
24.
BEARER FAIL
REPORT
set bearer_fail_report xxx
get bearer_fail_report
Value on/off. If on, you will receive SMS
(with additional information, as will be
explained in the SMS section) if: GPRS
activation failed; GPRS connection to
server failed; GPRS server could not be
created; CSD connection failed; CSD call
was not answered.
25. CLOCK
set clock xx:xx
get clock
This parameter is used to set the real time
clock of WirelessCom/G10. It is a 24
hours clock. Valid values are from 00:00
to 23:59
26. **AUTOCONNECT
set autoconnect xx:xx
set autoconnect xxxx
get autoconnect
This parameter allows you to configure
WirelessCom/G10 such that the device
will connect to the server at the
configured time. In clock-based approach,
time can be entered in terms of clock
hours (for this feature it is necessary to
configure the clock parameter) for
example,
15:30
this means everyday
WirelessCom/G10 will automatically
connect to the server at 15:30
.
In time-
based approach, time can be entered in
minutes (clock parameter does not need to
be configured) for example,
200
this
means WirelessCom/G10 will connect to
the server after every 200 minutes.
Table 7.1: WirelessCOM/G10 general configuration settings
* pin,puk,password are not displayed in the normal configuration menu (the menu which appears
when you type get and press enter). Instead you have to access them individually by typing get xxxx,
where xxxx is the name of configuration parameter.
** Autoconnect feature is only available for GPRS bearer in master mode. The feature is disabled
when WirelessCom/G10 is in configuration mode
*** If you are making CSD call to WirlessCom/G10, make sure that you are not hiding your caller
id. If not WirlessCom/G10 will not be able to recognize the incoming caller id and would reject the
call.
