23:
Ring Cadence, Second Phone Number
This command sets second phone numbers which can be programmed to ring
a single, double, or triple ring, with on and off times as specified in this
command:
*
23#a#b#c#d#e#f#
where:
a is the “on” time of the first ring, b is the
“
off
”
time of the first ring,
c is the on time of the second ring, and so on.
a, c, and e can be any numbers from 0 through 30 representing
tenths of seconds (30 = 3.0 seconds).
b, d, and f can be any numbers from 0 through 63 representing
tenths of seconds (63 = 6.3 seconds).
Default:
800 ms on, 400ms off, 800 ms on, 4 seconds off.
·
To disable ringing, enter:
*
23# #
·
To set the first on time and first off time to 30 and set the rest to 0 for
continuous 3 seconds on/3 seconds off ringing, enter:
*
23#30#30#
·
To set the on time to 30 and the first off time to 0 (i.e., continuous ringing),
enter:
*
23#30#0# #
Note
Programming a
“
0
”
for any value will cause all values following the
“0”to be ignored. All lines in a hunt group must be programmed
identically to avoid problems with Caller ID.
30:
Response to Busy
Determines the response that will be given to callers on
other lines
if this line is
busy when dialed.
·
To respond to callers with a busy signal (
default
), enter:
*
30#0#
·
To respond to callers with a reorder tone, enter:
*
30#1#
TLS-5 Reference Manual
Page 48
