08:
Confirmation and Error Tones
This command determines whether or not the TLS-5 will return confirmation
and error tones at the end of each programming command.
·
To disable the function so that no tones will be given.
*
08#0#
·
To enable the function so that tones will be given (
default
), enter:
*
08#1#
09:
Device Disconnect Timer
This command sets the time that the TLS-5 will wait before sending a
disconnect to the calling line if it remains off-hook at the end of a conversation
after the called line goes on-hook. The TLS-5A/B-02 and future releases,
support Calling Party Control (see Chapter 4 for details.)
Refer to command 38, Forced Disconnect.
*09#x#
where:
x is a number between 10-200 representing tenths of seconds (For
example, x=199=19.9 seconds)
(Default is 20 or 2 seconds.)
Note:
If a conference call is established, the disconnect timer value defaults to
2 seconds for the conference call. Subsequent calls revert back to the
programmed value.
60:
Dial Tone Number
This command programs a number that you can dial to hear continuous dial
tone. This is used to test or demonstrate how a device responds to continuous
dial tone.
*60#x#
where:
x = 0-16 digits
83781 or “TEST1”
(default)
61:
Busy Tone Number
This command programs a number that you can dial to hear busy tone. It is
used to test or demonstrate how a device responds to busy tone.
*61#x#
where:
x = 0 -16 digits
83782 “TEST2”
(default)
Chapter 6: Programming
40-400-00003, Rev.
E
Page 43
