·
Key the following:
*
33#1#
. (This enables audio port access for Line 1. You
will hear three beeps if the command is accepted.)
*
05#1#0#1#
(this
configures the audio port for immediate access, single user, disconnect at
end-of-message.)
·
Hang up.
Step 2:
Connect Audio Source
·
Use a standard cassette player cable (not supplied) with a 5-pin DIN
connector at one end and three connectors at the other (refer to Figure 2 to
connect the audio source to the TLS-5.
·
Plug 5-pin DIN connector into the TLS-5 Audio port.
·
Plug the connectors at the other end of the cable to the audio source as
follows:
—Connect the small gray cable to the control jack. (Remote.)
—Connect the black cable to the audio output from the source. (Ear.)
—The large gray cable is not used.
Note:
Cable colors will vary depending on manufacturer. See Figure 2.
·
Apply power and turn on the audio source (e.g., tape recorder.) If using a
tape recorder, press the play button.
TLS-5 Reference Manual
Page 26
Figure
3
End of Message Tape Sequence
