Chapter 3: Installation
Caution:
The TLS-5 generates up to 95 VAC ringing voltage.
Be sure the TLS-5
power switch is off before handling cord ends.
Step 1:
Connect power cord
·
Connect the AC power cord to the TLS-5 and to the wall receptacle. (A
power cord is not supplied with the TLS-5B/D.)
Step 2:
Connect telephones
·
Plug up to four telephones or other telecommunications devices into the
line jacks on the TLS-5 front panel.
Step 3:
Turn on power
·
Turn the TLS-5 power switch on.
Step 4:
Chassis ground (optional)
·
If a chassis ground is required, plug a 0.080-inch diameter pin probe into
the chassis ground reference Jack on the back panel. See Figure 1.
Step 5:
Audio port (optional)
·
To generate or play a recorded tape message, refer to Generating a Tape,
later in this chapter.
Demonstrating Equipment
Caution:
The TLS-5 generates 95 VAC ringing voltage.
Be sure the TLS-5 power
switch is off before handling any cord ends.
To demonstrate equipment, do the following:
·
With two devices connected to the TLS-5, place a call from one device to
the other by dialing the number of the other device. The default numbers
for Lines 1 through 4 are 101 through 104, respectively.
Note:
If you wish, you can change the phone number for any line to any digit
string from 1 through 16 digits by reprogramming the line as described in
Chapter 6.)
·
When the other line rings, answer the call. A connection should be
established and equipment features can be demonstrated.
·
When the call is completed, hang up both devices.
TLS-5 Reference Manual
Page 12