To select Line 4, enter:
*
04#
05:
Audio Access Mode
Use this command to specify the methods of access to and disconnection from
the audio port. This command is effective system wide. You can also enable or
disable each line’s access to the audio port. See command 33, Audio Port
Permission.
·
To program Audio Access mode, enter the command:
*05#x#y#z#
where:
x = access mode
x = 0, monitor mode
x = 1, immediate access
x = 2, dial access
(default)
y = connection mode
y = 0, single user
(default)
y = 1, multiple user
z = disconnect mode
z = 0, disconnect at on-hook
(default)
z = 1, disconnect at end-of-message
Monitor mode:
The audio port is automatically connected to the first line on
which the handset is lifted (if permitted by the setting of command 33) and the
call, including dialing, will be recorded. To use this mode, the command must
be entered as shown below:
*05#0#0#0#
where:
The command must be entered as shown above.
Immediate access:
The audio port is connected directly to one or more lines (if
permitted by the setting of command 33). No dial tone is given and dialing is
ignored.
*05#1#y#z#
where:
*05#1#0#0# - One user gets immediate access and remains
connected until on-hook
*05#1#0-#1# - One user gets immediate access and remains
connected until end-of-tape message is heard
*05#1#1#0# - Multiple users get immediate access remain connected
until phones go on-hook
*05#1#1#1# - Multiple users get immediate access and remain
connected until end-of-tape message is heard.
Dial up access:
Connects one or more users to the audio port (audio both to
and from the port) after the user dials the Audio Access number (command
06). The default is x = 2.
*05#2#y#z#
Chapter 6: Programming
40-400-00003, Rev.
E
Page 41
