Commands having multiple data fields can be abbreviated if the latter fields
are to be set to zero. For example,
*
05#2##
sets the audio access port to dial
access, single user, disconnect at off-hook.
If the TLS-5 accepts the code, you will hear a confirmation tone of three short
beeps. If the code is rejected, you will hear the error tone. If you hear error
tone, verify that the code and values you are trying to enter are valid, and try
again.
To correct command mistakes:
If you made an error in entering a command and have not yet entered a #, key
*
to cancel the command. When you hear three beeps, enter the command
again. Or re-enter the command from the beginning.
To correct data field mistakes:
If you made an error in entering within a data field, (that is, after one or more
#
s have been entered prior to the final #, key
*
to erase the current field back
to, but not including, the #, or
**
to cancel the entire command. When you
hear three beeps, re-enter the command.
To access Program mode
As explained below, there are two methods of accessing programming mode.
Generally, you can use either one. However, the second method (
**
99##
)
cannot
be used if the TLS-5 is programmed for “hot line” or direct audio port
access on Line 1. If Line 1 has been programmed for “hot line”, then use the
MAN/RING switch to enter the Program mode.
·
Lift the handset of the Line 1 phone. Press and hold the MAN/RING
switch position until you hear three beeps and the Line 1 light begins
blinking. Line 1 is automatically selected.
-or-
·
With Lines 2 through 4 on-hook. Pick up Line 1 and when you hear
dial tone, dial: **99##
·
Listen for three beeps and watch for the Line 1 light to blink.
·
To enter any of the per-line programming commands for Lines 2
through 4, you must first select the line using the commands
*
02#,
*
03#
, or
*
04#
. While any of these lines is selected, you can also enter
any system wide programming command. Enter any of the per-line
programming commands for Line 1, or any of the system wide
programming codes.
To exit Program mode
When you are finished programming, hang up.
The program codes and options are summarized for quick reference in
Appendix B.
Chapter 6: Programming
40-400-00003, Rev.
E
Page 33
