Chapter 2: Overview
The M-106E Remote Access Unit (Figure 1) enables off-premises users to dial
in to a PBX, key telephone, or CO Centrex system in order to access WATS, FX,
and tie lines, or other specialized services or to perform system maintenance.
The unit is microprocessor controlled, and provides a number of optional
features which you can configure through software using a DTMF telephone.
Operation
When an off-premises caller dials a telephone number dedicated to the
M-106E, the caller hears a special answer tone (in systems using a password)
or dial tone from the OUT line, if passwords are not being used. After
receiving answer tone, the caller dials a password. If the correct password is
entered, the caller hears dial tone from the OUT line indicating successful
connection to the M-106E. The caller then dials any system feature normally
available within the PBX or Centrex system. A caller can place more than one
call per incoming access using the reseize feature.
Note:
No battery backup is required because all features are stored in
permanent memory.
9.00"
5.50"
IN
OU
T
Remote Access
Unit
R
1.50"
Figure 1 M-106E Remote Access Unit
Chapter 2: Overview
106E-101, Issue 1
Page 3
