Remote Programming, WITH User Passwords
For setup procedures for operation with user passwords, follow the steps
below.
Step 1: Enter programming mode
No
te:
While the unit is in programming mode, calls are disconnected
whenever 2 minutes have elapsed without entry of a digit.
•
Press the front panel switch to PROGRAM until the green light flashes, or
request this service if you do not have access to the unit.
Step 2: Access the unit
•
Dial the M-106E telephone number and listen for three beeps.
Step 3: Enable password access
•
Enter the command:
*15*1#
•
Listen for three beeps to confirm that the command was entered correctly.
Note:
Whenever you make an error before the # is entered, enter 000# to
cancel the command, then begin again.
Step 4: Enable remote programming
•
Enter the command:
*98*1#
•
You will hear three beeps if the command was entered correctly.
Step 5: Assign system administrator password
•
Enter the following command (note that the password for User 1 must be
entered twice, as shown):
*1*1*NN...N#*1*1*NN...N#
where:
NN...N is the password (3 to 10 digits).
•
Listen for three beeps to confirm that the password is accepted.
Step 6: Verify password
•
Verify the password, if you wish, as follows:
*77*1*1#
Chapter 5: Programming the M-106E
106E-101, Issue 1
Page 21
