23
4.3 Spaces needed for use of the machine
The machine must be positioned on a solid, level and even
floor. It must not be directly exposed to sunlight or near to
heat sources.
Keep the machine air inlets clear to allow adequate air circu
-
lation around it.
4.4 Installation and assembly sequences of machine components
For safety reasons and to avoid damage during transportation, some machine components are removed from it. Therefore,
the machine user must follow these assembly instructions for machine components:
1 Drip tray
• Fit the drip tray (G) to the bracket (H) and install it on the support
(I) present on the front panel of the machine.
2 Dispensing tap
Install the dispensing tap (A) in the machine outlet (B), as follows:
•
Before inserting the tap turn its opening/closing lever (C) AN
-
TI-CLOCKWISE until it is vertical (OPEN position), otherwise the
tap may not be fully inserted in the outlet hole (B).
• Loosen the knurled knob (D) located on the dispensing tap.
• Insert the tap in the outlet and tighten the knurled knob in the seat
(E) located on the outlet.
• If necessary, lubricate with food-safe grease, supplied, the end
of the tap piston (F) and the related gaskets.
•
Turn tap opening/closing lever CLOCKWISE until it is in the closed
position (CLOSED position).
P
B
D
E
F
G
H
I
G
Chapter 4
Installation
TELME S.p.A.
Via S. Pertini, 10 - 26845 Codogno (LO)
Tel.: +39 0377 466.650 - [email protected]
Summary of Contents for EVOPASTO 120
Page 2: ...2...
