T. E. L. L. SOFTWARE
HUNGÁRIA KFT
48
Software settings:
Open the module's web interface, set the data for the serial port operation in the Remote Modules menu as
shown below:
Figure 51
.
Remote module:
Select the
„
Receive only
”
option from the dropdown list.
Connection type:
Select the
„
Continuous IP connection
”
option from the dropdown list. By this setting, the
connection between the programming software and the alarm control panel will be continuous.
Network:
In case the module has a 3G extension panel, the communication channel for transmitting serial data
also can be selected here.
Attention! Serial data transfer may result high data traffic, so please consider this before selecting 3G
network as communication channel.
Maximum data delay:
Recommended setting is 500 ms.
Serial port settings:
Recommended settings: Baud rate: 9600, Data bits: 8, Parity: None, Stop bits: 1.
For connecting the alarm control panel and programming software install the IP Bridge Virtual Client software.
This software connects the computer and the module and establishes a virtual serial data port that you need to
select in the programming software.
After starting the program, the following setting options are available:
Figure 52
.
