FORUM OPERATION AND MAINTENANCE MANUAL 9601
PAGE 47
PA/RECORDING
This switch determines the way in which the return input is routed.
In the PA mode, the metering will always read the group signal. If
the Ret/Bus switch is also set to Bus at this time, the return input
will take the group signal, and the external return signal will be
routed to the same group bus. This is useful for adding in sub-
mixersR for example, a stereo feed of a mix of keyboards from
another small console, which all then go off to the group output.
If the switch is set to Recording, the signals follow the Ret/Bus
switch selection, and no signals are routed from the return input
back to the group buses.
RET LEV
This is the level control for the return signal, and adjusts the
amount of level sent to the stereo mix.
SOLO
The return signal may be soloed to the monitoring system. This
solo signal is pre the return level control. The led in the switch
illuminates when solo is pushed.
ON
The ON switch enables the Return B signal to the stereo mix bus,
and has led indication when enabled.
SUB-LEFT
This will route the group output signal to the left channel of the
stereo mix bus.
SUB-RIGHT
This will route the group output signal to the right channel of the
stereo mix bus.
If both SUB-LEFT and SUB-RIGHT are pressed, the signal will
be fed via the Return 2 PAN pot to both left and right stereo buses.
Note that in this case, Return B can not be used.
FADER
The long throw fader controls the level of the group output. When
the SUB buttons are pressed, or BUS is selected, the fader will also
control the level of the signal sent to the stereo mix.