FORUM OPERATION AND MAINTENANCE MANUAL 9601
PAGE 20
AUXILIARIES
The Forum console has six auxiliary buses, accessed on the
Standard Input module from 4 controls. In addition, the channel
direct output may be controlled via one pot, to provide extended
auxiliary sends.
AUX 1
Controls the level of the channel signal fed to the Aux 1 bus. This
signal is normally post-fader, unless the PRE button, just below, is
depressed.
DIR
Re-routes the signal on the Aux 1 control to feed the Channel
Direct output. The signal no longer feeds the Aux 1 bus, and can be
used either as an additional single effects send, or as a feed to a
multitrack, for example.
PRE
Feeds the Aux 1 and Aux 2 controls with a signal taken pre-fader,
instead of post-fader. In this case, the signal on the Aux 1 & 2
buses is unaffected by the position of the channel fader.
AUX 2
Controls the level of the channel signal fed to the Aux 2 bus. This
signal is normally post-fader, unless the PRE button, just above, is
depressed.
AUX 3
Controls the level of the channel signal fed to the Aux 3 bus, and is
internally linkable to be pre or post-fader. When the 5-6 switch is
depressed, this control feeds the Aux 5 bus instead of the Aux 3
bus.
AUX 4
Controls the level of the channel signal fed to the Aux 4 bus, and is
internally linkable to be pre or post-fader. When the 5-6 switch is
depressed, this control feeds the Aux 6 bus instead of the Aux 4
bus.
NoteQ DIR, PRE, and 5-6 are local to the module, they do not affect
signal flow on any other module than the one on which they are
located.
