Telematrix Spectrum Plus LP550, User Manual

Page: 13 / 52

2. The Spectrum PLUS
TM
mounting wedge must
be correctly positioned. This wedge allows the
telephone to be viewed at a correct angle
when the phone is wall mounted. Remove the
wedge from the phone base (figure 2).
3. Secure the line cord, coil cord and any
wiring in place prior to installing the wall
mount wedge. The wall mount base has extra
large wiring channels and strain relief poles for
containing the wires in a neat and orderly way.
Wrap the wires around the strain relief poles
and then secure the wires through the
channel.
4. To install the wall mount, place it’s narrow
edge at the top edge of the phone base and
slide the wedge upward into place (figure 3).
5. Lock the wall mount into position by sliding
the locking button to the right (figure 4).
1. UNS NA P
2. RO TAT E 1 80 .
3. SN AP I NT O P LA CE.
1.LIFT CLIP OUT WITH
FINGERS. IT CANNOT
BE REMOVED BECAUSE
IT IS SPRING LOADED.
2. RTATE THE
CLIP 180
0
AND
IT WILL SMAP
BACK INTO THE OPPO-
SITE POSITION. AN
EXTENDED PLASTIC
BUMP WILL BE FACE-UP
FOR WALL MOUNTING
RETAINER CLIP
figure 1
Wall Mounting the Spectrum PLUS TM Telephone
To install the wedge for desk mounting, be sure the lock mechanism is positioned to the
left clear of the locking arm. Place the wedge in the slots, wide end toward top of phone
base unit, and slide the wedge upward into position. Lock the wedge into place.
Desk Mounting
Replace Mounting Wedge
Replace Mounting Wedge
Lock Mounting Wedge
The Spectrum PLUS
TM
was designed to be
conveniently wall mounted without requiring
additional hardware.
Follow these easy steps:
13
figure3
figure 4
figure 2
NOTE: CLIP IS SPRING
LOADED
Note: A 6-inch line cord is provided for when
the telephone is to be wall mounted. Connect
one end of the line cord to the phone jack and
the other end to the wall jack.
!
1.The handset retaining clip must be in the
correct position to secure the handset into the
handset cradle. Engage the clip with your
fingers and pull the clip forward (towards you),
rotate the clip 180º and snap the clip back into
place (figure 1). The retaining clip cannot be
removed.