Programming the Area Code into Memory
An Area Code can be programmed into the phone memory at the option of the
Administrator. The Area Code is programmed into memory to allow the phone to
recognize the local area code. When this number is programmed, the Are Code
WILL NOT be dialed when calling back a number within the same local calling
area.
Programming the Area Code into Memory
1. Press the “STORE” key the programming mode.
2. Press the “STORE” key multiple times until “ENTER AREA CODE” is
displayed.
3. Enter the area code number of the local area code using the numeric dial
pad.
4. Press the “STORE” key to store the area code into memory.
5. To exit the program mode, press “DISC” or continue to the end of
programming by pressing the “STORE” key multiple times until the display
reads “All Setup OK”.
In some areas, the Area Code is required when placing a Local Call
In some areas, the local service provider will use the same area code for local
calls. The following options are available.
Try each of the following scenarios and use the one with the best result.
1. Program the Area Code first, then place a local test call.
2. Delete the area code and do not program the Access Code. Place a local
test call.
3. Program the Area Code into the Access Code location. Place a local test
call.
4. Use the keypad to add additional numbers to the displayed number on
the screen. Place a local test call.
ENTER AREA CODE
12/01
PM
12:00
719 - -
ENTER AREA CODE
Set up local area code
to recognize local in-
coming calls.
19
NOTE: Depending on your area and dialing pattern, you may obtain the best result
by using both the access code and area code fields. If these sequences do not work,
use the keypad entry as an option for your Call Back.
!
Summary of Contents for Spectrum Plus LP550
Page 2: ...This page is intentionally left blank...
Page 6: ...TOP PANEL 6...