Telematrix Spectrum Plus LP550, User Manual

Page: 12 / 52

Connecting the Handset Cord
A 10-foot modular coil handset cord is
provided. (Be sure that the wall/desk
elevation stand has not been attached).
To install the cord, simply plug the short
end of the handset cord into the modular
jack on the handset. The long end of the
handset cord plugs into the jack labeled
“Handset” located on the bottom of the
Spectrum PLUS
TM
base unit. Route the
handset cord into the handset coil cord
channel located directly below the jack.
Installing the Keycaps
Twenty-two silk-screened named feature
keycaps are provided to identify the
speed dial key.
There are eleven (11) clear keycaps
already installed. To install pre-printed
keys, remove the clear keycap by simply
pulling up. Replace with the pre-printed
keycaps or place user printed paper
index sheets under a clear keycap.
Program each speed dial key for the spe-
cific function of the key.
There are four additional clear keycaps and two index sheets provided as
spares. Use these for your own personal speed dial identities. Hand write or
print the speed dial name(s) on the blank speed dial index cards and insert into
the blank keycaps. Place the keycap on the correct memory speed dial location.
(see index sheets provided in box).
The twenty-two silk-screened keycap names are below:
Call Fwd On Call Back Paging Skip Msg Information
Call Fwd Off Cancel Call Back Ring Again FF Msg 911
Transfer Call Park Save Msg Rew Msg
Conf Call Pick-up Del Msg Emergency
DND Group Call Pick-up Rpt Msg Help Desk
NOTE: For speed dial programming instructions, see the section on “Programming Procedure For
Spectrum Plus
tm
Speed Dial Features” in this manual.
12