ADR-7000 / SAVER-7000 / GUARD-7
© 2017
– Telefire Fire & Gas Detectors Ltd
Revision 0.98 October 2017
– Page 62 of 87 –
Device Type
: the device type as follows:
Photoelectric Detector
: (TFO-480A or TFO-440A)
Heat Detector
: (TFH-280A or TFH-220A). Detector mode (Fixed Temperature
(default) or Rate of Rise) is defined in the Mode field.
Gas Detector
: reserved for future use
Input Module
(ADR-712; ADR-718; ADR-812A or ADR-818A).
Mode
can be
Alarm; Reset; Silence; Disconnect; Supervisory; Abort; Release; Alarm Matrix;
or Fan PC).
Switch
: (a manual call point (TPB-800ASR, TPB-800ASY, or TPB-101ASM),
an input of an ADR-805A or ADR-705; or the IDC input or an ADR-723 or
ADR-823A). Switch operating mode is defined in the
Mode
field, and can be
Alarm; Reset; Silence; Disconnect; Supervisory; Abort; Release; Alarm Matrix;
or Fan PC.
Power supply
: an auxiliary power supply (TPS-34A)
Sounder
(TIP-224A, or an ADR-723 or ADR-823A output that activates
sounders). Operation mode is defined in the Mode field and can be No
Protocol or with the Control Panel's protocol.
Lamp
: an ADR-723 or ADR-823A output that activates a strobe
Extinguisher
: an ADR-723 output that is used to release extinguishant. The
Mode field specifies pulse length (5 seconds to 239 minutes, or continuous until
reset). Default is 15 seconds.
Extinguisher Control
: (ADR-833A).
Control Out
: the output of an ADR-723 or ADR-823A; or the relay of an
ADR-723, ADR-823A, or an ADR-741). The
Mode
field defines whether it is
activated by an alarm or a fault.
Isolator
: an addressable line isolation module (LI-3000)
CO & Heat Detector
: reserved for future use
Photo & Heat Detector
: (TPH-482A or TPH-442A)
Supervisory Out
: the output of an ADR-723 or ADR-823A; or the relay of an
ADR-723, ADR-823A, or an ADR-741 that is activated as a result of a
Supervisory event.
i
Note
A supervisory input or switch and its related supervisory out should be in the
same logical zone.
Fire Phone Jack
: (TFP-806)
Fire Phone Lamp
: (and address of a TFP-828)
SCM
: the relay of an ADR-723, or an ADR-741 that is intended to activate or
stop a smoke control blower.
Zone
: the device's logical zone. Can be in the range of 1
– 511.
Mode
: the device's operating mode, device dependent.
For heat detectors: fixed temperature or rate of rise
For Input module: Alarm; Reset; Silence; Disconnect; Supervisory; Abort;
Release; Alarm Matrix; or Fan PC
