Teledyne Oldham MX 16, User Manual

Page: 36 / 60

MX 16
ANALOG AND DIGITAL CONTROLLER
USER GUIDE
32 NP16EN
Revision: A.0
Delete allows for the deletion of this entire monitoring file. Up to 512 events can be memorized.
Beyond that, the most recent event deletes the oldest.
Previous page, Next page, and Last page allow access to the corresponding pages of the file;
each page can display a maximum of 8 lines.
Message Significance
Line 1
On/Off Start or stop line 1
Line 2
On/Off Start or stop line 2
Detectors
On/Off Start or stop the detector
External
ack.
Press the external acknowledgement button
MX 16 ack
Acknowledgement by the acknowledgement button on the front plate of
MX 16
Simulation Switch to simulation mode
Calibration At least one of the detectors is selected in calibration mode.
Test
detectors Switch to test mode
Program Programming done on
MX 16
Time
settings Time settings on
MX 16
Table 7: Operation monitoring file messages.
5. Hardware troubles records
This displays, for each material incident detected: incident ID, status (activated = ON or
deactivated = OFF) as well as the date and time of occurrence or release of the event.
Previous page, Next page, and Last page allow access to the corresponding pages of the file:
each page can display a maximum of 8 lines.
Message Significance
DEAD Digital module no longer responding (line cut, module failure, wrong
address, module absent).
MODUL Configuration or module address error.
TEMP+ Internal temperature of the
MX 16 higher than maximum tolerated value.
TEMP- Internal temperature of the
MX 16 lower than maximum tolerated value.
LINE 1 Incident on line 1 (short-circuit).
LINE 2 Incident on line 2 (short-circuit).
CAL O Calibration defect (zero shifted).