Teledyne Oldham MX 16, User Manual

Page: 33 / 60

MX 16
ANALOG AND DIGITAL CONTROLLER
USER GUIDE
NP16EN
Revision: A.0
29
procedure.
2. The detector is calibrated.
5. Sensor exchange
This function reboots the parameters (rate of wear, calibration date, internal parameters
corresponding to the 4-20mA range, etc.) from the selected detector(s) following or in view of a
change of cell.
Detector Selection
1. Select the detector(s) to be rebooted with the help of the Previous detector, and Next detector
keys and press Select.
Initialization of the Detector
1. Press Escape to reset the selected cells
2. Proceed with the cell replacement and then calibrate locally the corresponding detectors
3. Proceed with the calibration from the MX 16 via the menus “1 Sel detectors”, “2 recording”,
"End recording” and “4 validation” in order to save data calibration (wear rate, date of
calibration, response time, etc.).
4. Maintenance
Access
Successively press the keys Menus and Maintenance.
1. Line On/Off
Sets the line to stop (the line is not powered and the detectors are at stop; no event can be
generated from then on).
2. Detector On/Off
Sets the detector to stop (no event can be generated from then on) if it was not issuing an alarm
or failure.
3. Test On/Off
This allows for the verification of the proper operation of a detector. In this mode, recordings and
alarm relays are suppressed.
4. Simulation
Upon its selection, the message “The controller no longer ensures detection” is displayed.