Teledyne Oldham MX 16, User Manual

Page: 32 / 60

MX 16
ANALOG AND DIGITAL CONTROLLER
USER GUIDE
28 NP16EN
Revision: A.0
4. Validation
This allows the adjustment and validation of zero and detector sensitivity once calibration is
completed.
Figure 21: Adjustment of zero (left) and sensitivity (right)
Operating mode
1. Press Validate.
Zero calibration
1. The Zoom command is active.
2. Select the area of interest of the curve with the

and

keys. Press Zoom + up to the
activation of the Zero command. Adjust the position of the cursor so as to make the “OK”
appear, in turn indicating that the range selected is sufficiently stable.
3. Press  to select the term Zero.
4. Confirm the zero calibration by pressing Validate zero.
5. The term Sens (for sensitivity) is active from now on.
If sensitivity is not to be calibrated, press  and END; until you see the message “Do you only
want to calibrate zero for the detector?”, then press Validate calibration. Only the zero
calibration of the detector will have been carried out.
If sensitivity is to be calibrated, proceed directly to the following paragraph.
Sensitivity calibration
1. The Sens command is active.
2. Select the area of interest of the curve with the

and

keys. Press Zoom + up to the
activation of the command Sens. If applicable, adjust the position of the cursor so as to make
the “OK” appear, in turn indicating that the range that has been selected is sufficiently stable.
3. Confirm the sensitivity calibration by pressing Validate Sens.
Record the calibration
1. The message “Do you want to validate zero and detector sensitivity?” is displayed. Press
Validate calibration to confirm the adjustment of zero and sensitivity or Esc to exit the