Teledyne 6 RU Chassis, Operation Manual

Page: 153 / 172

6 RU SSPA Chassis Operations Manual 202058 REV AA 153
This section describes the procedure for setting up the RM SSPA Ethernet IP interface
through the front panel interface. It also describes basic network setup of a Windows
based host PC for a peer-to-peer network connection with the RM SSPA.
Important! Do not use a crossover cable to connect to the network hub, use crossover
only for direct PC-to-RM SSPA connection!
1. Connect J6 Ethernet Port of the RM SSPA controller to a host PC through a crosso-
ver null-modem network cable (see
Appendix B
) for wiring details.
2. If the PC NIC card has not previously been set, do so now using the following proce-
dure, otherwise skip to Step 3.
2.1 From Windows Control Panel select Network icon;
2.2 Select TCP/IP properties of your LAN card. The window shown in
Figure A-1
will
appear:
2.3 Select "Specify an IP Address". And enter the following parameters in the IP ad-
dress and Subnet fields:
IP Address……………: 192.168.0.3
Subnet Mask………….: 255.255.255.0
After you press "OK", depending on the operating system, you may need to reboot the
workstation.
Figure A-1: TCP/IP Properties Window
Appendix A: Ethernet Interface
Quick Set-Up