Sentinel V Real-Time Quick Start Card
Ethernet
95D-6030-00 (September 2017)
Information included herein is controlled by the Export Administration Regulations (EAR) and may require an export license, license exception or other approval from the appropriate
U.S. Government agency before being exported from the United States or provided to any foreign person. Diversion contrary to U.S. law is prohibited.
Preparing the ADCP
To connect the cable:
1. Remove the dummy plug from the ADCP.
2. Connect the external I/O cable connector to the ADCP.
3. Connect the I/O cable Ethernet connector to your computer.
4. Connect the AC Power Adapter to the power connector or
use the banana plugs from cable 73D-6021-00 to power the
unit with a different power supply (voltage not to exceed
20V).
5. Plug the adapter into a 100-240 VAC 50/50 Hz source.
6. When power is applied, you should hear a long beep. If you
do not hear the beep, check the cable connection and
power before continuing.
Next step is
. Continue to
the next page.
If you need help, read the Real-Time Deployment
Guide.
How do I know if the system is Ethernet?
Look for the labels next to the product label.
RT = Real-Time, Eth = Ethernet.
Sentinel V Real-Time ADCP with Straight Connector Shown
The figure above shows the no battery RT housing,
but any V Series housing with End-Cap connector can
be used.
If your system uses batteries, see the corresponding
Self-Contained Quick Start Card.