September
2017
Sentinel V SC and RT Operation Manual
Page 222
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
Performance and Testing Commands
The Sentinel V Real-Time uses the following commands for calibration and testing.
Available Performance and Testing Commands
This section lists the available Performance and Testing commands.
>P?
Available Commands:
PA ---------------------- Run Go/No-Go Tests
PC ---------------------- Built In Tests [0=help]
PD 0 -------------------- Set Output Format (0=ensemble)
PS ---------------------- System Info [0=config,3=xform,5=HEM,6=RSSI Cal]
PT ---------------------- Built-in-Test Commands; PT0=Help
PF ---------------------- Results from most recent PA tests
P? ---------------------- Display P-Command Menu
>
Performance and Testing Command Descrip-
tions
PA – Run Go/No-Go Tests
Purpose
Sends/displays results of a series of Sentinel V Real-Time system diagnostic tests.
Format
PA
Recommended Setting. Use as needed.
Description These diagnostic tests check the major Sentinel V Real-Time modules and signal paths.
These tests check the following boards/paths.
•
DSP - RAM, ROM, and DSP-to-CPU Communications.
•
Sensors - verifies sensor operation.
Example
see below
>pa
* indicates override value, selected by EZ command
RTC test............PASS
FPGA test...........PASS
Compass test........PASS [ 1.74, 1.40, -179.55 ]
Temperature test....PASS [ 25.335 ]
Pressure test.......PASS [ 97.00 ]
GO
>